|
My older Delta gauge, which wore out after about 16 years of use, had a better pointer and scale so that it was easier to get an accurate reading. The needle pointing to the degree mark is removed from the scale by about 1/8 to 1/4 inch, so the reading is hard to see precisely. The pointer was right on the scale. Delta makes a fine product. I am mostly happy with it.
After milling the saw table tracks so they were true, but slightly oversized is no longer a problem. It's doesn't have laser cut stops or any high-tech features.
This is a good, simple, well-made, easy to set-up and use basic gauge. I always double check my angles with a protractor, no matter what gauge I'm using.
The miter tracks in my old saw were worn to the point where my miter gauge no longer stayed true. The gauge is beefy and has a "good feel".
It does exactly what it's designed to do. The Delta miter gauge uses simple allen adjusters that compensate for the wear.
I adjusted the miter gauge screws for a snug fit and I'm back in business.
I think the small screws that hold the adjustment plate in place under the head are not rated for the 3 foot drop test, putting the guage back to square is simple enough though. If you have or get one that wants to test gravity check the settings before you make a cut that really counts. This guage dose not like the sudden stop from a dive off the top of my saw but what ones do.
It is fast to set up with very easy to make adjustments IF needed. The VERY minor things I have had to tweak are the slippery face of the head which was very easy to fix by adding shelf stick sand paper and putting a small amount of thread locker on one of the miter slot adjustment screws to keep it from backing out and allowing the guage to wiggle in the table slot. I have been using this gauge for about 4 months and am very happy with it.
You can adjust this guage to fit worn table slots to a Perfect no slop slide which we all know makes for the best cut. If Delta made a add-on fence this guage would be right up there with the other Best guages. Right out of the box mine was set to a perfect 90 and 45.
The guage has a bigger head than all of my older guages which makes for Excellent support for any cut.
Good unit. Adjustment to all frequently used settings is both very fast and very accurate, and the working gage surface is nicely machined and large enough to provide adequate support (and control) for any of my typical workpieces. This purchase was intended to simply replace a broken unit. It is, however, a substantial upgrade from the stock unit that Delta supplied with my saw.
It it well made easy to align and hold alignment. Nitre guage was to replace the OEM unit.
|
